Baumer DSRK Betriebsanleitung Seite 5

7.1 Assembly
ATTENTION
False measurement results via contaminated measuring head or incorrect assembly
Avoid contamination from grease or oil.
f
„
Do not touch scanning surfaces on the measuring head with bare hands.
f
„
The machine element must not touch the strain probe housing after assembly.
f
„
1
2
10 mm
3
4
www.baumer.com
Force and strain sensors
Strain Probe DSRK
Simple strain measurement in deep holes
9 Hole must be prepared.
Carefully take strain probe out of the packaging.
f
„
When doing so, follow safety instructions on the
packaging.
Insert strain probe into the hole with a slow
f
„
continuous movement.
Insert strain probe so far that 10 mm of the tube
f
„
of the probe remains visible.
Turn sensor housing in clockwise until back
f „
pressure becomes noticeable.
ATTENTION! Excessive tightening torque can
f „
damage the measuring head. Keep precisely to
the specified tightening torque.
Tension strain probe with torque wrench
f
„
(hexagon socket SW6).
Tightening torque: 16 Nm.
Operating Instructions 5 / 28