Displayed Messages - V-ZUG 74A Bedienungsanleitung

DISPLAYED MESSAgES

DISPLAYED MESSAgE
FILL TANK
GROUND TOO FINE ADJUST MILL
(alternating with)
PRESS OK
GROUND TOO FINE ADJUST MILL
(alternating with)
PRESS OK
(then)
FILL TANK
EMPTY GROUNDS CONTAINER
INSERT GROUNDS CONTAINER
ADD PRE-GROUND COFFEE
DESCALE
(alternating with)
COFFEE STANDARD
LESS COFFEE
FILL BEANS CONTAINER
INSERT INFUSER ASSEMBLY
CLOSE DOOR
GENERAL ALARM
EMPTY CIRCUIT FILL CIRCUIT
alternating with
HOT WATER PRESS OK
POSSIBLE CAUSE
The water tank is empty or
positioned incorrectly.
The grinding is too fine and the
coffee is delivered too slowly.
The tank has been removed during
delivery.
There is air in the hydraulic circuit.
The grounds container (A4) is too
full or more than three days have
passed since you last made coffee
(this guarantees correct hygiene of
the machine).
After cleaning, the grounds container
has not been replaced.
The "pre-ground coffee" function has
been selected without placing any
pre-ground coffee in the funnel.
The funnel (A21) is blocked.
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The infuser has not been replaced
after cleaning.
The service door is open
The inside of the appliance is very
dirty.
The water circuit is empty
21
SOLUTION
Fill the tank with water and/or insert it correctly,
pushing it as far as it will go.
Turn the grinding adjustment dial one click clockwise
towards "7".
Insert the tank and press the OK button (B4).
"HOT WATER PRESS OK" is displayed.
Press the OK button (B9) again.
The appliance is once again ready for use.
Empty the grounds container and clean, then replace.
Important: when removing the drip tray, the grounds
container MUST be emptied, even if it contains few
grounds.
If this is not done, when you make the next coffees, the
grounds container may fill up more than expected and
clog the machine.
Open the service door and insert the grounds
container.
Extract the appliance and place pre-ground coffee in
the funnel.
Empty the funnel with the help of a knife as described
in the section "Cleaning the pre-ground coffee funnel".
The descaling procedure described in the "Descaling"
section needs to be performed as soon as possible.
Select a milder taste or reduce the quantity of pre-
ground coffee, then make the coffee again.
Fill the beans container
Insert the infuser as described in the section "Cleaning
the infuser".
Close the service door.
Clean the inside of the appliance thoroughly, as
described in the section "Cleaning and maintenance".
If the message is still displayed after cleaning, contact
a service centre.
Connect the hot water nozzle (A10) and press OK to
deliver water from it, until it flows out normally.
EN