Changing The Quantity Of Coffee In The Cup; Programming Quantity; Adjusting The Coffee Mill; Making Espresso Coffee With Pre-Grounded Coffee - V-ZUG 74A Bedienungsanleitung

pressing the previously selected button which remains lit during
the operation.
NOTE 5: As soon as delivery is finished, to increase the quantity
of coffee in the cup, just keep pressing the previously selected
button within 3 seconds after delivery has finished.
NOTE 6: When the appliance displays "FILL TANK", fill the tank
with water or the appliance will not deliver coffee.
(It is normal for there to be a little water left in the tank).
NOTE 7: After about 14 single (or 7 double) coffees, the appliance
displays "EMPTY GROUNDS CONTAINER".
To clean, open the service door on the front of the appliance
by pulling the spout (fig. 16), extract the drip tray (fig. 17) and
clean.
When cleaning, always extract the drip tray completely.
Important! When extracting the drip tray, the groun-
ds container MUST always be emptied.
If this is not done, the machine may be clogged.
NOTE 8: Never extract the water tank while the machine is de-
livering coffee.
If it is removed, it will not be possible to make the coffee and the
appliance will display some messages (see page 21).

CHANgINg THE QUANTITY OF COFFEE IN THE CUP

The appliance is set by default to make a standard quantity of
coffee.
To select the quantity of coffee, press the
peatedly until the message corresponding to the required quan-
tity of coffee is displayed:
Corresponding coffee
ESPRESSO
COFFEE
LONG COFFEE
(B3) button re-
quantity (ml)
≃30
≃110
≃150
13

Programming quantity

To modify the quantity of coffee delivered, proceed as follows:
1. Place a cup under the coffee spouts ( fig. 9).
2. Keep the (B4) button pressed until the message "PRO-
GRAM QUANTITY" is displayed and coffee delivery begins.
Then release the button.
3. As soon as the coffee in the cup reaches the required level,
press the same button again.
The quantity set has now been programmed.

ADJUSTINg THE COFFEE MILL

The coffee mill is preset in the factory and should not require
adjusting.
However, if after making the first few coffees you find that deli-
very is either too fast or too slow (a drop at a time), this can be
corrected by adjusting the grinding adjustment dial (fig. 14).
Important! The grinding adjustment dial must only
be turned when the coffee mill is in operation.
For slower delivery and creamier coffee, turn one click anti-
clockwise (finer pre-ground coffee).
For faster delivery (not a drop at a time), turn one click clockwise
(coarser pre-ground coffee).
MAKINg ESPRESSO COFFEE WITH PRE-gROUND
COFFEE (INSTEAD OF BEANS)
• Press the button (B2) (fig. 8) and select the pre-
ground coffee function.
• Extract the machine by pulling it outwards using the han-
dles (fig. 7).
• Lift the central lid, place one measure of pre-ground coffee
in the funnel (fig. 19), push the appliance in then proceed
as described in the section "Making coffee using coffee be-
ans".
Please note: You can make just one coffee at a time by pres-
sing the button (B4) (fig. 12).
• After using the machine with pre-ground coffee, to go
back to making coffee using beans, disable the pre-ground
coffee function by pressing the
EN
button (B2) (fig. 8)