Measurement; Unit Of Measurement; Hold Function; Max/Min/Avg Mode - PCE -T 330 Bedienungsanleitung

5.3

Measurement

- Turn on the meter and connect the probe.
- Attach the probe to the object you wish to measure or place it in the air (depending on
the type of probe) and view the reading on the display.
Note:
When the alarm function is enabled, the visual alarm is triggered once the temperature is above
the high limit or below the low limit. The alarm stops when the reading goes below the upper or
above the lower threshold again. In order to save power, the alarm will stop after 10 minutes.
5.4

Unit of measurement

Press the °C/°F key
5.5

Hold function

- Press the HOLD key
in a smaller font above the held reading.
5.6

MAX/MIN/AVG mode

In dual channel merge mode or dual channel difference mode:
- Press the MAX/MIN/AVG key
minimum and average values of channel 1 and 2 in large font one after the other,
followed by the current reading. The current reading will also be displayed in real time
above the MAX/MIN/AVG value in small font.
- Press F1 (Reset) to reset the maximum, minimum and average values.
- Press the MAX/MIN/AVG key
mode.
In single channel one mode or single channel two mode:
- Press the MAX/MIN/AVG key
average values.
- To reset the maximum, minimum and average values, press the F1 key
(Reset).
- Press the MAX/MIN/AVG
mode.
5.7

Backlight

When the meter is turned on, press the backlight key
deactivate the backlight, press the same key again.
to change the unit of measurement.
to hold a reading. The current reading will be displayed
© PCE Instruments
24
several times to see the maximum,
again to exit MAX/MIN/AVG view
to view the maximum, minimum and
key again to exit MAX/MIN/AVG view
to activate the backlight. To