How To Select The Probe Type - PCE -T 330 Bedienungsanleitung

Single channel trend graph description
1
2
3
4
5
6
Note:
The maximum temperature of the trend graph is set to be 105 % of the maximum measured
temperature over the past 35 seconds. Therefore, the temperature values displayed on the screen
may be outside the displayed range but this does not mean that the instrument can measure
temperatures outside the measurement range. The same is true for the lowest temperature of the
trend graph.
5.2

How to select the probe type

In dual channel merge mode or dual channel difference mode:
- Press the PROBE key
- Press F1
channel number.
- Press F2
channel number.
In single channel mode:
- Press the PROBE key
type will be shown in the upper part of the display for about 3 seconds.
Maximum temperature
Minimum temperature
Timeline
"-" icon indicates that time in seconds is in the past
High alarm limit value
Temperature curve
Low alarm limit value
. "PROBE" will flash in the status area.
until the desired probe type for channel 1 is displayed next to the
until the desired probe type for channel 2 is displayed next to the
to switch the probe type directly. The current probe
© PCE Instruments
23