Getting Started; Power Supply; Preparation; Turning The Meter On/Off - PCE -T 330 Bedienungsanleitung

4

Getting started

4.1

Power supply

- The instrument is powered by three 1.5 V AAA batteries or 1.2 V rechargeable batteries
under normal conditions.
- The USB interface can provide 5 V voltage in cases of emergency. However, unstable
USB power supply will result in measurement inaccuracies. Therefore, USB power
supply is not recommended.
- Insert the battery/rechargeable battery into the battery compartment. Observe correct
polarity.
4.2

Preparation

- Remove the protective film from the display.
- Insert the probe plug into the probe socket of the instrument.
4.3

Turning the meter on/off

- Press the on/off key
number can be viewed on the screen by pressing the °C/°F key
entering the measurement interface.
- Press and hold the on/off key
5

Operation

5.1

Channel mode

The instrument has two temperature measurement channels and four mode interfaces which can
be used flexibly to meet different measurement needs.
The four mode interfaces are shown in the following chart:
Channel Dual channel
mode merge mode
Example
Feature Both channels are
measured and
displayed
simultaneously.
to turn on the instrument. The version number and serial
. When "shut down" is displayed, release the key.
Single channel Single channel
one mode two mode
Shows Shows
temperature temperature
curve of channel curve of channel
1 in the past 35 2 in the past 35
seconds. seconds.
© PCE Instruments
22
before
Dual channel
difference mode
Shows
temperature
differences
between channels
1 and 2.