container by tilting the pulp container slightly to the right and unlatch it from under the
juicer cover and the container support extending from under the motor base. Replace
the empty pulp container into position before continuing to juice.
Note:
Do not use force removing the pulp container to avoid damage to the juicer
cover.
Note:
In case that the appliance slows down, stumbles or stops all of a sudden
turn off the appliance immediately and pull the plug to avoid overheating. Operate
according to the instructions ´Trouble shooting guide`.
WARNING:
Never use fingers to push food down the feed chute or to clear the
feed chute. Always use the food pusher provided.
Note:
Pay attention not to overflow the jucie jug.
As soon as you finished operating turn the appliance ´OFF`. Always turn the appli-
ance ´OFF` and pull the plug when the appliance is not in use and you finished the
operation. Clean the appliance in accordance to the instructions in chapter 'Care
and Cleaning`. Do not leave any food dry on the surfaces of the appliance or the
filter basket.
DISASSEMBLING YOUR DESIGN JUICER
WARNING:
Always turn the appliance 'OFF' and pull the plug when the appli-
ance is not in use or when disassembling, moving or cleaning the appliance. Never
let water or other liquids run into the motor block. Never clean the line cord or the
motor block in the dishwasher, poor liquids over the appliance or douse or dip it in
water or other liquids.
Step 1:
Push the 'ON/OFF' button on the juicer to 'OFF' and then switch 'OFF' at the power
outlet and unplug. IMPORTANT: Wait for the filter basket to stop spinning before
continuing to step 2 Carefully remove the pulp container by tilting the pulp container
slightly to the right and unlatch it from under the juicer cover and the container sup-
port extending from under the motor base.
Step 2:
Pull the locking arm back over the grooves on either side of the juicer cover. Move
the locking arm down.
Step 3:
Lift the juicer cover off the juicer.
45