SATO TG3 Serie Schnellanleitung Seite 6

Do not use in locations with high humidity
Do not place the printer in any places where it will be subjected to high humidity or condensation. If
condensing, turn off the power switch immediately, stop using it and dry completely without using
any heat producing devices. Continued use under these conditions may cause electric shock.
Carrying the printer
• Disconnect the power cord from a power outlet before moving the printer to other places.
Leaving it connected and moving the printer will damage to the cord and connections. This may
cause fire or electric shock.
• Do not carry the printer when the label is set. If the label falls and hits someone, it could cause
injury.
• When placing the printer on the floor or the table, be careful not to get your fingers or hands
caught in the legs of the printer.
Power supply
Do not touch the power switch or plug-in/unplug the power cord with wet hands. This may cause
electric shock.
Power cord
• Keep the power cord out of any appliances that produce heat. This may melt the coating of
power cord and cause fire or electric shock.
• When disconnecting the power cord from the printer or a power outlet, pull on the plug. If not, it
may cause exposure of wire, breaking of wire, overheating, fire or electric shock.
• The power cord provided with this printer is for use with this printer only. It cannot be used with
other electrical devices.
Cover
When opening/closing the cover, be careful not to get your fingers caught.
6
CAUTION