SATO TG3 Serie Schnellanleitung Seite 17

Automatic Feeding Function
The automatic feeding function automatically transports paper detected with the jump hole sensor to the head position when
paper is loaded in the printer.
When paper is inserted in the lid latch part while the printer is in the offline state after the head and lid latch are opened/
closed, this function uses the jump hole sensor to detect the paper and then performs the automatic feed operation.
If the head and lid latch are opened/closed, paper is loaded manually, and then the Online key or Feed key is pressed, the
feed operation is performed in order to position the paper, but this operation differs from the automatic feed operation.
Cutting without Wasting First Tag/Label
When using the tag/label longer than its maximum length in automatic feeding function, the printer feeds out a blank tag/label.
Tag/Label specification not to issue a blank tag/label.
Tag/Label Type
Center Hole Tag
I-Mark Tag/Label
Side Hole Tag
R-Corner Tag
Label with Gap
Maximum Length
140 mm/5.51 inches
65 mm/2.55 inches
200 mm/7.87 inches
65 mm/2.55 inches
70 mm/2.75 inches
17