SATO TG3 Serie Schnellanleitung Seite 15

4 Load the paper.
Push the roll firmly toward the inside of the printer until it
touches the back of the spindle.
5 Attach the roll paper stopper.
When using a large quantity of paper (Ø 100 outer diameter
core), attach the extension guide plates.
6 Close the cover.
CAUTION
When closing the cover, please be careful not to
get your fingers caught in the cover.
Setting the Standard Cutter Unit Paper
1 Turn the power ON.
"PAPER END" is displayed on the LCD.
2 Turn the head lock lever counterclockwise and then clockwise to lock the head.
The ONLINE LED goes OFF and the paper type is displayed on the LCD.
3 Press the PAPER button until the paper you want to use is displayed on the LCD.
4 If you use tag stock, adjust the cutter sensor position. If you use label paper, proceed to Step 5.
Loosen the adjustment screw to move the cutter sensor according to the scale on the gauge and then tighten the adjustment
screw.
Roll paper stopper
15