Technical Specification; Connecting The Hob To The Mains Power Supply - KKT KOLBE CC9001IND Benutzerhandbuch

Technical specification / Connection

13. Technical specification

Cooking Zones
Supply Voltage
Installed Electric Power
Product Size L×W×H(mm)
Building-in Dimensions A×B (mm)
Weight and Dimensions are approximate. Because we continually
strive to improve our products we may change specifications and de-
signs without prior notice.

14. Connecting the hob to the mains power supply

The power supply should be connected in compliance with the rele-
vant standard, or a single-pole circuit breaker.
• If the cable is damaged or needs replacing, this should be done by
an after-sales technician using the proper tools, so as to avoid any
accidents.
• If the appliance is being connected directly to the mains supply, an
omnipolar circuit breaker must be installed with a minimum gap of
3mm between the contacts.
• The installer must ensure that the correct electrical connection has
been made and that it complies with safety regulations.
• The cable must not be bent or compressed.
• The cable must be checked regularly and only replaced by a pro-
perly qualified person.
• The installer must to use the H07RN-F power cord.
Please always check whether built-in bridges on the connection
ports have influence on your power concept.
4
380-415V 3N ~ , 50Hz-60Hz
7400 W
770x520x60
750x495
!
67