Trouble Shooting; Storing In Winter - Swim & Fun Pro Mini 200 Handbuch

10. Trouble shooting
Problem
At start the pump is running
but not pumping water into
the pool.
The pressure gauge shows a
pressure exceeding 1.0 bar
Pressure is to low
Water escapes from
backwash valve.
Leaking filter connection
(between filter and top valve)
The pump is not running
Sand in the pool
Pump sucks air (Bubbles at
the inlet)
Skimmer or pump gets too
little water
NOTE:
Repairs of the sand filter and pump may only be performed by a qualified, professional
firm. Otherwise, the warranty will be void.

11. Storing in winter

At the end of the summer season, disconnect the hoses, remove water from the filter by opening the
drain valve (8). Water MUST be emptied from the pump as well and it must be placed in a dry place,
where it cannot be damaged by the cold. The pump and filter tank cannot endure frost – it will make
damages the materiel and the warranty is no longer valid. Put the handle in WINTERIZE position.
Page 40
Cause
Air trapped inside suction hose.
Pump is not placed in the level of the
pool bottom
Dirty filter sand
Suction hose/skimmer basket/pump
or filter to valve can be blocked by
leaves or debris
The gasket around the 7-way valve is
dirty and leaky. Grit in the gasket.
Damaged gasket or sand
The filter system has been deactivated
by the filter timer or a filter control.
The plug is not connected.
The HFI device turns the pump off.
Damaged pump motor.
If the filter sand is new, there may be
small grains which are washed out or
the filter tank.
Defective hoses
Hose clamps are too loose
Water level is too low
MV-1080-09-2016 . Swim & Fun Scandinavia . info@swim-fun.dk . www.swim-fun.com
Solution
The pump must be located at ground level
below the water line!
Prime the hoses. (See procedure pkt. 6)
Carry out a backwash of the filter sand
Clean suction hose/pool skimmer and top val-
ve. Check feeding hose connections for air.
The 7-way valve should be removed from the
filter lid, the gasket should be cleaned.
Inspect the gasket and replace with a new
one if necessary.
Examine the settings.
Connect the plug.
Turn on the HFI device again. If it immedia-
tely turns itself off again this means that the
pump or the HFI device is damaged.
Replace the pump.
Carry out repeated backwash until the
backwash return water is totally clear.
Replace the hoses
Tighten hose clamps
Check water level and increase if necessary
© All rights reserved Swim & Fun Scandinavia ApS 2016