Cleaning The Bottom Of The Pool - Swim & Fun Pro Mini 200 Handbuch

9.

Cleaning the bottom of the pool

1. Switch the pump off. Use a hose clamp to connect a pool hose to the round suction plate of the
pool skimmer. Alternatively place a pool hose into the bottom of the skimmer. This will demand
a sucking hose with a special muff connector.
2. Make sure all air comes is out of the hose before cleaning. Fill the hose with water by holding it
in front of the inlet to the pool while the pump is running. The air will hereby come out. The hos-
es can be air free under water using a weight load. That could be a weighted vacuum cleaner
mounted on a telescopic pole.
3. Set the lever on FILTER. Switch the pump on and brush the bottom and the walls. Make sure
no air enters as it could defuse the pump or cause damage to it by making it work without wa-
ter.
4. When cleaning is finished, stop the pump, turn the lever to BACKWASH, switch the pump on
and wash for one minute to eliminate dirt. Switch the pump off, set the lever on RINSE and
switch the pump on for half a minute for a light rinse. Cleaning operations are now finished.
NOTE:
If you clean your pool with a pool vacuum cleaner, this can also be done with the 7-way
valve in the position WASTE to remove impurities from the pool (eg. dust particles),
which otherwise go back through the filter sand. In doing so, the water will be directly
pumped through the backwash line into the sewer. Remember to refill the pool with wa-
ter afterwards this process.
MV-1080-09-2016 . Swim & Fun Scandinavia . info@swim-fun.dk . www.swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS 2016
Figure 11
Page 39