Switching The Compressor On - EKOM DK50 4VR/50 Die Anleitung Zur Installation, Bedienung Und Wartung

13.

SWITCHING THE COMPRESSOR ON

(Fig.10)
Switch on the compressor at the pressure switch (2) by turning the
knob (3) to position "I." (for compressor in the box switch (37) Fig.4), on
the front part of the compressor box), The compressor sends
pressurized air to the air tank. As the compressed air is used, the
pressure in the air nozzle drops to a preset level, the compressor
switches on and the air nozzle files with compressed air.
reaching the cutoff pressure the compressor turns off automatically and
the cycle is repeated. Check the value of switching-on and switching-
off pressure on pressure gauge. The values may be within a tolerance
of 10%. Air pressure in air chamber must not exceed maximal
permitted operation pressure..
Never tamper with the pressure switch (2). Adjustments are not allowed. The pressure
switch (2) has been set by the manufacturer and further setting of switching on and off
pressure may be carried out only by a qualified expert trained by the manufacturer.
CONTROL PANEL SCREENS FOR THE NDL DRYER
Status messages
Low pressure
-
24-hour regeneration mode
-
NP-DK50 4VR50-3_09-2014
-Supplier
-Supplier contact
-Operating hours
-Chamber A (B) in operation
a) From compressor start-up until pressure reaches 5.5 bar
b) During operation if pressure drops below 5.1 bar
Dryer regeneration for 10 minutes is automatically switched
on after 24 hours of compressor operation.
- 18 -
DK50 4VR/50
1
4
After
5
Fig
.10
3
2
09/2014