Preparation For Use; Use/Operation - Ottobock 757L35 Gebrauchsanweisung

7 Preparation for Use

7.1 Use/Operation

1) Insert the European power supply adapter or the US power supply
adapter into the power supply until it snaps into place (Fig. 1).
2) Connect the power supply or the optionally available 4X74 Car Charging
Cable to the MyoCharge Integral. Ensure correct polarity (Fig. 2).
3) Plug the power supply into a wall socket.
4) Connect the charging plug to the charging receptacle and allow it to
snap into place (Fig. 3).
5) The charging process starts automatically if LED 1 shows blue light (Fig.
4, arrow) and the beeper of the charging receptacle sounds.
6) The current battery charge level is indicated by LEDs 2-5 lighting up in
sequence (Fig. 5).
7) Once charging is complete, the charging plug can be disconnected. If
the charging plug remains connected, the battery charger will switch to
permanent charge (trickle charge). This will not damage the battery or
charger.
INFORMATION: The charging plug may be disconnected at any
time. Partially charging the battery does not shorten its lifespan
(no memory effect).
8 Troubleshooting
8.1 Charging Indicators
LED illuminated
LED flashing
Explanation of symbols
Ottobock | 15