Charging The Batteries; Attaching The Belt Clip; Changing The Display Language - Unify OpenScape DECT Phone S5 Base Bedienungsanleitung

Getting started

Charging the batteries

¤
Charge the batteries fully prior to first use in the
base station/charging cradle or using a standard
USB mains adapter (
The batteries are fully charged when the power icon
disappears from the display.
The handset may only be placed in the designated base station or charging cradle.
The battery may heat up during charging. This is not dangerous.
After a time, the charge capacity of the battery will decrease for technical reasons.
Handsets contained in the package have already been registered to the base station.
In the event that a handset is not registered however, (indicated by "Bitte Mobilteil
anmelden"), register the handset manually (

Attaching the belt clip

The handset has notches on each side for attaching the belt clip.
•
Attaching the belt clip:
handset so that the tabs on the belt clip click into place in the
notches.
•
Removing the belt clip:
with your right thumb.
between the clip and the casing.
remove.
Setting up the telephone for use

Changing the display language

You can change the display language, if the telephone has been set to an incomprehensible
language.
¤
Press middle of the control key
¤
Press the keys
language settings display appears, the set language
(e. g. English) is highlighted (
¤
Select different language:
desired language is marked in the display, e. g. French
the key on the right directly underneath the display to activate the language.
¤
To revert to idle status:
78
p. 79).
Press the belt clip onto the back of the
Press the centre of the belt clip firmly
Push the nail of your left thumb up
Slide the clip upwards to
.
and slowly and successively . . . the
= selected).
Press the control key
Press and hold the End call key
7 h
p. 107).
Deutsch
English
Francais
until the
press