Chapter 7 - Storage And Maintenance; Recommended Maintenance; Storage And Transport - CareFusion SprintPack Bedienungsanleitung

Chapter 7
This section explains how to store and maintain the SprintPack Li-Ion Power
System.

Recommended Maintenance

The following items should be routinely checked for integrity and changed
when necessary:

The SprintPack batteries are maintenance free and only require
recharging. After 400 cycles per battery, replace the SprintPack Battery
with CareFusion P/N 19444-001.

For the servicing of all other items, such as a worn cord connector or
damaged wire contact CareFusion.

The SprintPack Li-Ion Power System is a solid-state device that
requires no ongoing service under normal operating conditions.
WARNING
Risk of electrical shock. Do not attempt any servicing of the SprintPack
Li-Ion Power System.

Storage and Transport

Storage and transport of the SprintPack Li-Ion Power System and batteries
affects their cycle life.

When not in use, remove the SprintPack Batteries from the
SprintPack Power Manager. If necessary, they may remain
housed in the Power Manager with the connection points
disengaged. This will allow the batteries to hold their charge for the
next time they are put to use. The SprintPack Batteries should be
stored with a charge level of 30 – 50% (2 – 3 lit LEDs) to optimize
shelf life.

Self-discharge of each battery depends upon storage temperature.
A lower temperature decreases this discharge and allows the
batteries to be stored for longer periods.
18415-001, Rev. E
- S
TORAGE AND
Operator's Manual - SprintPack™
M
AINTENANCE
7-1