Advice On Use - Parkside PTKS 1800 Bedienungs- Und Sicherheitshinweise

www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++
Or
EMERGENCY SWITCH OFF:
• BLADE HEIGHT ADJUSTMENT WHEEL :
Set the blade height (cutting depth) by turning the hand wheel .
• BLADE ANGLE ADJUSTMENT THUMB KNOB
The inclination angle of the saw blade can be set to any angle between 0° and 45°.
The required angle can be easily determined from the scale.
Warning: After every setting of the angle always fix/secure the saw blade in place – turn the
safety lock thumb knob
• GUIDE FENCE :
Attach the guide fence at both ends by tightening the screws and use the scale with the magnifying
glass to determine the exact readings in order to achieve an absolutely straight cut (see Fig. E).
• MITRE GUIDE :
Use the mitre guide only when fully installed (with the guide rails). Slide the mitre guide from the
front into the groove in the saw table. By loosening the clamping screw, the angle can be set to
± 60°, see Figs. C and F.

ADVICE ON USE

Always switch on the table saw before bringing the material into contact with the blade.
Then feed the workpiece evenly from the front towards the back of the machine.
SAWING
01. First set the required blade height. Please make sure that: the dust cowl
clearance from the workpiece.
02. If required set, the blade angle as described above. Then fix/secure the saw blade with the safety
lock thumb knob
03. Attach the guide fence.
04. Switch on the machine as described above.
05. Slide the workpiece evenly from the front to the back of the machine, see figures B and D.
Saw the workpiece in one operation.
Use the push stick if the distance between the guide fence
06. Switch off the machine immediately if you are not going to continue to use it
Press the cover of the ON/OFF switch
to the right.
by turning it to the right.
/ SAFETY LOCK THUMB KNOB :
and the blade is
t
18
closed.
has about 10 mm
120 mm.