Mounting/Setting The Guide Fence; Connecting The Sawdust Extraction Appliance; Operation; Switching On And Off - Parkside PHKS 1350 A1 Originalbetriebsanleitung

WARNING!
GB
► The arrow on the saw blade
spond to the arrow showing the direction of
rotation (running direction shown on the
device).
■ Ensure that the saw blade
rotational speed of the tool.

Mounting/setting the guide fence

♦ Loosen the wing screw
fence into the guide fence slot
♦ Set the desired cut width with the help of the
scale on the guide fence
arrow in the base plate
Fig. B: Cutting width 3 cm
♦ Retighten the wing screw
Connecting the sawdust extraction
appliance
♦ Attach the adapter for dust extraction
chip ejector
♦ Connect an approved dust and chip extraction
device.

Operation

Switching on and off
Switching on:
♦ Push the safety lock-out
and keep it pressed.
♦ Press the ON/OFF switch
running you can release the safety lock-out
Switching off :
♦ Release the ON/OFF switch
8
All manuals and user guides at all-guides.com
must corre-
is suitable for the
and insert the guide
.
and the marking
(see also Fig. B).
45 45 0
.
.
to the left or right
. Once the saw is
.

Setting the cutting angle

You can select the cutting angle with the help of the
cutting angle scale
■ Release the wing screw on the cutting angle
preselector
cutting angle scale
wing screw.

Setting the cutting depth

NOTE
► We generally recommend setting the cutting
depth to approx. 3 mm more than the thickness
of the material. This ensures that you achieve
a clean cut.
♦ Release the locking screw
cutting depth on the cutting depth scale
then re-tighten the locking screw

Working with the circular saw

1. Switch on the device – as described in "Switching
on and off " – and then place it with the front
edge of the base plate
2. Align the machine using the guide fence
by using a marked line.
3. Hold the machine in both hands using the
handles and saw by exerting an even pressure.
Switching the laser on and off
Switching on:
to the
♦ Press the ON/OFF switch laser
Switching off :
♦ Press the ON/OFF switch laser
NOTE
► If the batteries are spent, replace them with
two new 1.5 V alkaline button cells (type
AG 13/LR 44, e.g. GPA 76) .
.
.
, set the desired angle on the
and then re-tighten the
, set the desired
.
on the material.
.
.
PHKS 1350 A1
and
or