40
2.1.2
Tear-off contact
Screw the tear-off contact (eye with lead) directly to the mounting surface using the enclosed screw and spacer
sleeve. Dowels may be necessary, depending on the mounting surface.
2.1.3
Pull-relief
Use a cable binder to attach the connecting cables to the pull relief
Observe the information on the mains supply in
Chapter 7.1.
2.1.4
Solder bridge - function (from V02.xx)
- Solder bridge open:
- Solder bridge closed:
2.2
Alarm signalling device
2.2.1
Overview
AVOID INJURY TO EYES!
The device is equipped with LEDs Class 1M
(EN 60825-1).
Do not look directly into the light beam of the flashing LEDs
- danger to eyes. Do not use tightly converging instruments
(lenses) for observing the light beam. Only use the alarm
signalling device together with the housing cover (glare and
diffusor protection).
LEDs for alarming
Cover contact
Alarm device
Fixing holes
Tear-off protection
Cable entry
Pull relief
Mounting and Operating Instructions Doorguard hardwired version
Acoustical and optical alarms are stopped in two separate operating steps
Acoustical and optical alarms are stopped in one common operating step
RISK OF GLARE
due to strong light!