Configuration Example Ii; Configuration Example Iii; Remote And Indicating Panel - Operating Functions - Honeywell 041460.17 Montage- Und Bedienungsanleitung

54
5.1.9

Configuration example II

Example for maximum configuration in the event of networking (16 Doorguard hardwired versions):
Remote and indicating panel
Address 0
5.1.10

Configuration example III

Example for minimum configuration in the event of networking (1 Doorguard hardwired version device and 1
remote and indicating panel:
Remote and indicating panel
Address 0
The other programmable functions can be used for every Doorguard hardwired version device irre-
spective of possible networking.
5.1.11

Remote and indicating panel - operating functions:

Every key and LED besides the key assigned to a Doorguard device. Address 1 - Key 1 (top left column).
Address 2 - Key 2 and so on.
! By a key operation toggles the state of the Doorguard between inactiv (also automatic activation),
manual activation and activ again.
! In the active state, without triggering, all LED's are dark.
! The green LED on the LED keypad, resp. the yellow LED on 012542.XX and 012548.XX shows:
- permanent lit, the inactive state (also automatic activation).
- 1:1 flashing, a manual activation.
! The red LED shows an open door, oder when triggering an alarm.
! The red flashing LED shows the missing communication to the Doorguard - (fault / user fault).
! The buzzer announce an acoustic alarm (depend on programming until alarm stop).
Mounting and Operating Instructions Doorguard hardwired version
Number of Slave-devices (Addr.)
15 devices = Address 1 up to 15
Programming "Master", setting of highest address
Route wires between the Doorguard hard-
wired version device and remote indicating
panel as shown in the diagram.
Master-device (Addr.)
Programming "Master", setting of
highest address = Address 15
Master-device (Addr.)
(in this case) = Address 0