Wall Mounting; Mounting With Ground Stake - LIVARNO LUX IAN 288476 Montage-, Bedienungs- Und Sicherheitshinweise

fastening the fixing screws. Use the pliers to tighten the cord anchorage
on the cord (Fig. D). Fix the cord by turning the nut of the cable
14
gland (Fig. E).
13
Place the protection plastic cover
Make sure the seal ring
before close (Fig. D).
Close the connection box
(Fig. G).

Wall Mounting

Place the mounting bracket
for the mounting bracket.
Now drill the fastening holes (Ø 8 mm) and push the wall plugs
the drill holes.
Insert the included screws
Fix the mounting bracket on the wall using the screws provided.
Align the spotlight
to slacken the locking screws
tighten the locking screws of the hinge joint again, to ensure a secure
hold.

Mounting with ground stake

Loosen the knurled screws
ground stake, using the knurled screw, onto the middle hole of the
mounting bracket
12 GB
18
is correctly fit on the connection box
17
again by fastening the fixing screws
6
on the wall and mark the fastening holes
5
into the washers
3
into the desired direction. For this, you may need
4
of the hinge joint. After alignment,
7
of the ground stake
11
.
5
on the terminal block
(Ø 20 mm).
2
10
(Fig. F).
15
6
12
into
1
and secure the