Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONTENTS
1.
2.
2.1.
2.2.
2.3.
3.
4.
5.
5.6.
5.7.
6.
7.
7.1.
8.
8.2.
GENERAL
1.
Read this documentation carefully before installation. Installation and functioning must comply with the
safety regulations in force in the country in which the
product is installed. The entire operation must be carried out in a workmanlike manner and exclusively by
skilled technical personnel (paragraph 2.1.) in possession of the qualifications requested by the regulations in
force. Failure to comply with the safety regulations not only causes risk to personal safety and damage to the
equipment, but invalidates every right to assistance under guarantee.
Keep this manual with care for further consultation even after the first installation.
2.
WARNINGS
2.1.
Skilled technical personnel
It is indispensable that installation be carried out by competent, skilled personnel in possession of the
technical qualifications required by the specific legislation in force.
The term skilled personnel means persons whose training, experience and instruction, as well as their
knowledge of the respective standards and requirements for accident prevention and working conditions, have
been approved by the person in charge of plant safety, authorizing them to perform all the necessary activities,
during which they are able to recognize and avoid all dangers. (Definition for technical personnel IEC 364).
2.2.
Safety
Use is allowed only if the electric system is in possession of safety precautions in accordance with the regulations in force in
the country where the product is installed (for Italy, CEI 64/2).
2.3.
Responsibility
The Manufacturer does not vouch for correct operation of the set or for any damage that it may
cause if it has been tampered with, modified and/or run outside the recommended work range or
without the aid of our control and protection panels.
The Manufacturer declines all responsibility for possible errors in this instructions manual, if
due to misprints or errors in copying.
modifications to products that it may consider necessary or useful, without affecting the essential
characteristics.
3.
INSTALLATION
3.1.
The set must be fitted in a well ventilated place, protected from unfavourable weather conditions and with
an environment temperature not exceeding 40°C (fig.1).
Position the set in such a way that any maintenance jobs can be carried out without difficulty.
ENGLISH
The company reserves the right to make any
22
page
22
22
22
22
22
22
23
23
24
25
25
25
25
26
26
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
