Particular Warnings; Responsibility; General; Applicazioni - DAB DIVERTEK 500 Installations- Und Wartungsanleitungen

Overload protection. The pump is equipped with a thermal motor protector. If the motor overheats, the motor protector switches
the pump off automatically. The cooling time is about 15-20 min. after which the pump automatically switches on again. After the
motor protector has tripped, it is absolutely necessary to find the cause and eliminate it. See Troubleshooting.
The power supply cable and the float switch must never be used to carry or lift the pump. Always use the pump handle.
Use is allowed only if the electric system is in possession of safety precautions in accordance with the regulations in force in the
country where the product is installed (for Italy CEI64/2).
Never pull on the cable to detach the plug from the socket.
If the power cable is damaged, it must be replaced by the manufacturer or by their authorised technical assistance service, so as
to avoid any risk.
Failure to observe the warnings may create situations of risk for persons or property and will void the product guarantee.

Particular warnings

Always switch off the mains power supply before working on the electrical or mechanical part of the system. Only firmly
cabled mains connections are admissible. The appliance must be earthed (IEC 536 class 1, NEC and other applicable standards).
Mains terminals and motor terminals may still have dangerous voltage when the motor is stopped.
The appliance may only be used for the functions for which it was designed.
Under certain calibration conditions, the converter can start automatically after a power failure.
The Manufacturer does not vouch for correct operation of the electropumps or answer for any damage that they may cause if they
have been tampered with, modified and/or run outside the recommended work range or in contrast with other indications given in this
manual.
The Manufacturer declines all responsibility for possible errors in this instructions manual, if due to misprints or errors in copying. The
Manufacturer reserves the right to make any modifications to the products that it may consider necessary or useful, without affecting their
essential characteristics.
1

GENERAL

1.1

Applicazioni

Powerful multistage submersible pump ideal for rainwater systems, operating sprinklers, pumping water from cisterns, tanks, ponds and other
applications that require high pressure. Anti-corrosive and dust proof materials, overload protection, wear resistant shaft, anti-debris
technopolymer strainer, excellent cooling of the motor allowing the pump to run even if partially submerged, automatic start/stop function with
floating switch. Supplied with non-return valve and 4-step fitting.
These pumps cannot be used in swimming pools, ponds or basins where people are present, or for
pumping hydrocarbons (petrol, diesel fuel, combustible oils, solvents, etc.) in accordance with the acci-dent-prevention
regulations in force. They should be cleaned before putting them away. See the chapter "Maintenance and Cleaning".
ENGLISH

RESPONSIBILITY

8