Overheating Protection; Control Panel - ESAB EMP 215ic Betriebsanweisung

6 CONTROL PANEL

5.9

Overheating protection

The welding power source has overheating protection that operates if the
internal temperature becomes too high. When this occurs the welding
current is interrupted and an overheating symbol appears on the display.
The overheating protection resets automatically when the temperature has
returned to normal working temperature.
6 CONTROL PANEL
General safety regulations for handling the equipment can be found in the "SAFETY
PRECAUTIONS" chapter of this manual. General information about operation can be
found in the "OPERATION" chapter of this manual. Read both chapters thoroughly
before you start using the equipment!
After power on has completed the main menu appears on the control panel.
0463 408 001
Duty cycle on 230V AC
Welding current (AMPS)
- 22 - © ESAB AB 2016