Connections - ESAB EMP 215ic Betriebsanweisung

5 OPERATION
WARNING!
Tighten the bobbin locking nut in order to prevent it from sliding off the hub.
100 mm (4")
5.1

Connections

Front and rear:
1. Knob for current or wire feed speed
selection
2. Display
3. Knob for voltage selection
4. Main knob for menu navigation
5. Torch/Remote control connection
6. Negative output [-]
0463 408 001
200 mm (8")
7. Polarity changeover cable
8. Positive output [+]
9. Euro torch connector
10. Mains cable
11. Mains supply switch ON/OFF
12. Gas valve inlet
- 15 - © ESAB AB 2016