Lowering The Vehicle; Cleaning And Care; Maintenance And Storage; Topping Up The Hydraulic Oil / Greasing - ULTIMATE SPEED HG02971 Bedienungs- Und Sicherheitshinweise

Place the axle stands under the designated
jacking points under the vehicle.
Relieve the load from the vehicle jack by
placing the rod
7
on to the release valve
rod slightly anticlockwise before turning
7
it back immediately. The support plate
drops slightly and the vehicle is held on the
axle stands.

Lowering the vehicle

Q
DANGER TO LIFE! Check that no person
or object is under the vehicle before you
lower it.
CAUTION! Lower the vehicle slowly, other-
wise there is the danger of injury and damage
to the product or to the vehicle.
First raise the vehicle slightly in order to be
able to remove the axle stands. Proceed as
described in the section on „Raising the
vehicle".
Remove the axle stands.
Place the rod with oval opening on to the
7
release valve and turn the rod slowly
5
anticlockwise (Fig. C). The vehicle is lowered
slowly.
Note: The more quickly the rod
turned anticlockwise, the faster the vehicle
is lowered. Therefore you should proceed
very cautiously at first in order to get a feel-
ing for the correct speed.
Lower the support plate
longer loaded. Then pull the vehicle jack
out from under the vehicle. Press down on
the support plate
Close the release valve
rod on the release valve
7
Take the rod off the release valve
7
If it is extended, screw the extension screw
back down into the jack body.
2
8 GB/CY
with the oval opening
, then turning the
5
1
is
7
until it is no
1
until it is fully lowered.
1
by turning the
5
clockwise.
5
5

Cleaning and Care

Q
L iberally grease all external moving parts.
C lean the hydraulic trolley jack using a
slightly oily cloth.
N ever use harsh or corrosive cleaning agents.

Maintenance and storage

Q
Topping up the
Q
hydraulic oil / greasing
Note: Use only hydraulic oil that complies with
ISO VG 15.
Stand the vehicle jack upright on a level,
flat surface.
Screw the extension screw
down into the jack body.
Place the rod
the release valve
clockwise (Fig. C) until the support plate
is fully lowered.
Pull the oil plug
Introduce hydraulic oil from a suitable ves-
sel into the oil reservoir. Fill the hydraulic oil
reservoir up to the bottom edge of the filling
opening.
Remove any air present in the hydraulic sys-
tem. To do this follow steps 3–4 in section
on "Removing air from the system".
Replace the oil plug
reservoir opening.
Grease all moving parts on the vehicle jack
regularly to prevent corrosion.
Top up with approximately 100–105 ml oil
if all the oil has been used up.
.
Removing air from
Q
the hydraulic system
Air in the hydraulic system may detrimentally af-
fect the proper functioning of the vehicle jack.
completely
2
with oval opening on to
7
and turn the rod anti-
5
out of the oil reservoir.
8
back into the oil
8
1