Storing; Troubleshooting; Disposal - ULTIMATE SPEED HG02971 Bedienungs- Und Sicherheitshinweise

Proceed as follows to remove air from
the hydraulic system:
1. Place the rod with oval opening on to
7
the release valve
clockwise (Fig. C) until the support plate
is fully lowered.
2. Pull the oil plug
8
3. Guide the lifting handle
handle socket
3
several times to allow any air to escape.
4. Place the rod with oval opening on to
7
the release valve
wise (Fig. C). The release valve
closed again.
5. Replace the oil plug
reservoir opening.
6. If necessary, repeat steps 1–5 until all the
air has escaped.

Storing

Q
Place the rod with oval opening on to
7
the release valve
clockwise (Fig. C) until the support plate
is fully lowered.
Screw the extension screw
down into the jack body.
Store the hydraulic vehicle jack and the lifting
handle in a dry environment and protected
from moisture.
Ensure that the support plate
lowered and the extension screw
pletely screwed in before you put away the
vehicle jack. This will prevent the oil escap-
ing from the oil plug
Grease all moving parts on the vehicle jack
regularly to prevent corrosion.

Troubleshooting

Q
= Fault
= Cause
= Remedy
and turn the rod anti-
5
out of the oil reservoir.
into the lifting
6
and pump it up and down
and turn the rod clock-
5
is now
5
back into the oil
8
and turn the rod anti-
5
completely
2
is fully
1
is com-
2
.
8
= The vehicle jack does not raise the vehicle
at all or does not raise it high enough.
= The release valve
= Close the release valve
the section on "Raising the vehicle").
1
= There is not enough hydraulic oil in the
vehicle jack.
= Top up the hydraulic oil (see the section on
"Topping up the hydraulic oil / greasing").
= There is too much hydraulic oil in the cylinder.
= Remove the excess quantity of hydraulic oil
from the cylinder.
= There is air in the hydraulic system.
= Remove the air in the hydraulic system (see
the section on "Removing air from the hydrau-
lic system").
= The vehicle jack gives way under load.
= The release valve
= Close the release valve
the section on "Raising the vehicle").
= Hydraulic oil escapes.
= There is too much hydraulic oil in the cylinder.
= Remove the excess quantity of hydraulic oil
1
from the cylinder.
= The pump mechanism works only partially.
= There is too much hydraulic oil in the cylinder.
= Remove the excess quantity of hydraulic oil
from the cylinder.
= There is air in the hydraulic system.
= Remove the air in the hydraulic system
(see the section on "Removing air from the
hydraulic system").

Disposal

Q
The packaging and ancillary packing
consist entirely of environmentally-
friendly materials. They can be disposed
of at your local recycling facility.
In the interest of the environment, do
not throw out the product with your
household refuse. Take it to a suitable
centre where it can be disposed of
was not properly closed.
5
completely (see
5
was not properly closed.
5
completely (see
5
GB/CY 9