Herunterladen Inhalt Inhalt Diese Seite drucken

Assembling The Lifting Handle; Distribution Of The Hydraulic Oil; Using The Jack; Raising The Vehicle - ULTIMATE SPEED HG03844 Bedienungs- Und Sicherheitshinweise

Hydraulic trolley jack
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Firstly, attach one side of the handle to nut
on the jack.
Secondly, strech the carry handle so that
the other side also attach firmly to the nut
on the jack.

Assembling the lifting handle

Simply push in the lifting handles
to assemble. Push the button to release the
handles
for storage.
1
The storing brackets
storing the lifting handle
Distribution of the
hydraulic oil
With the release valve
the lifting handle
socket
. Use at least 6 firm pumping
6
movements to charge the hydraulic system
(move lifting handle
action distributes the hydraulic oil evenly.
Note: Check that the release valve
by inserting the lifting handle
turn it clockwise (see Fig. A). DO NOT OVER
TIGHTENED! When you cannot turn it any
further, the release valve
The hex nut
must be tightened before use.
11

Using the jack

Raising the vehicle

With the release valve
lifting handle
into the lifting handle
1
socket
(see Fig. B).
6
Place the hydraulic vehicle jack under one
of the lifting positions as shown in the owner's
manual supplied by the vehicle manufacturer.
Ensure that the support plate
loaded. By moving the lifting handle
and down, raise the vehicle sufficiently to allow
8
GB/IE/NI
together
1
can be used for
12
.
1
closed, insert
5
into the lifting handle
1
up and down). This
1
is closed
5
and trying to
1
is closed.
5
closed turn the
5
is centrally
3
1
you to insert axle stands under the vehicle
(see Fig. C).
Allow the vehicle to come down on to the
axle stands by slowly opening the release
valve
by turning the lifting handle
5
anticlockwise.
The jack is NOT FOR HOLDING the
vehicle.

Lowering the vehicle

DANGER TO LIFE! Check that no person
or object is under the vehicle before you
lower it.
First raise the vehicle slightly (as described
earlier) in order to be able to remove the
axle stands.
Turn the release valve
the vehicle lowers, but do not turn it to the
extent that it detaches or hydraulic oil leaks
from the release valve
CAUTION! Lower the vehicle slowly, other-
wise there is the danger of injury and damage
to the product or to the vehicle.
Pull the trolley jack out from under the vehicle
and fully lower the lifting arm
Close the release valve
clockwise.
Attaching the adapter
(optional)
From its original height (13.5 cm), bring the
vehicle jack to a height of 34 cm by moving
the lifting handle
section on "Using the jack").
Note: Do not lift the jack to the topmost
position, allow more space for attaching the
adapter
9
Remove the hex bolt
with a socket wrench plus socket (19 mm)
and a ring spanner (19 mm) (see Fig. E).
Place the adapter
up
. From above, guide the hex bolt
3
through the adapter
(see Fig. F).
anticlockwise until
5
(see Fig. D).
5
.
2
by turning it
5
up and down (see the
1
.
from the nut
10
on to the load plate
9
and load plate
9
1
11
10
3

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis