Items Supplied; Raising The Vehicle; Description Of The Appliance; Preparatory Steps - ULTIMATE SPEED URW 2 A1 Bedienungsanleitung

Items supplied

1 x Trolley Jack
2 x Lifting rods
1 x Carrying grip
1 x Operating instructions

Description of the appliance

q Lifting lever
w
Loading plate
e
Carrying grip
r
Release valve
t Lifting lever collet
y
Securing points for the carrying grip
u
Adjusting screw

Preparatory steps

1. Attach the carrying grip
y
securing points . Ensure that the carrying grip
e
is not overloaded and breaks.
2. Push the lifting levers
Turn them until they are secured against being
pulled apart.
3. Place the lifting levers
r at the front.Turn it clockwise to close it
completely.
4. Now place the lifting levers
collet t .
5. Turn the lifting levers
secure against being pulled out.
6. On the first utilisation or after an extended
period of non-usage, first pump the Trolley Jack
without any loading (6-7 pump movements).
This distributes the hydraulic oil evenly again
inside the device.
e
e to one of the two
q into each other.
q
onto the release valve
q
in the lifting lever
q
clockwise until they are

Raising the vehicle

Important: Refer to the vehicle owner's
handbook to find out where the lifting points are
located. To avoid damage, the vehicle may only
be raised at these places.
1. Push the loading plate
middle below the lifting point.
Note: Ensure that you place the vehicle jack in
such a position that the lifting levers
under the vehicle.
2. To start, only pump until the loading plate
just touching the lifting point. This permits you to
make corrections if needed.
3. Now raise the vehicle until you have sufficient
clearance to position the axle stands.
4. Permit the vehicle to drop onto the axle stands in
that you slowly open the release valve
turning it in an anti-clockwise direction.

Lowering the vehicle

1. First raise the vehicle a little to remove the axle
stands.
2. Then, with the lifting lever
r
release valve
allow the vehicle to descend.
3. As soon as the Trolley Jack is removed from
under the vehicle, the loading plate
completely pressed down with the foot.
- 15 -
w to exactly in the
q
r
q , slowly turn the
(anti-clockwise) and carefully
w
can be
are not
w is
by