Use; Raising The Vehicle - ULTIMATE SPEED HG02971 Bedienungs- Und Sicherheitshinweise

jack for correct seating and look out for
hydraulic oil leaks in particular.
Never use the hydraulic vehicle jack for
moving or loading a vehicle. Never use it to
lift a whole vehicle completely off the ground.
Make sure that no-one – especially a
child – is in the vehicle and that everyone is
kept at an adequate distance away from
the vehicle when the hydraulic vehicle jack
is in use.
Never change the setting of the safety valve
. It is preset to the correct setting in the
4
factory and must never be readjusted later.
Do not use the hydraulic car jack if the seal-
ing (safety valve ) is damaged.
4
Before using the vehicle jack, the user must
be made familiar with the device by an ex-
perienced person. The pump force and the
transferred force are equal to approximately
350 N.
If the markings on the product are damaged
enough so as to be illegible then the vehicle
jack must not be used until the markings are
renewed.
No modifications may be carried out to the
hydraulic bottle jack. Any physical modifica-
tion of the device and its compliance with
EN 1494/A1: 2008.
The applied force when using the vehicle
jack must not exceed 350 N. The equates to
a force on the lever of approximately 35 kg.
CAUTION! RISK OF SHEAR-
ING AND CRUSHING IN-
JURY! Keep your fingers away
from the area of the lifting handle socket
while pumping. Failure to observe this advice
may result in shearing and crushing injury.
The operating temperature of the hydraulic
oil of this equipment is between -20 °C to
+40 °C.
Do not use this equipment in rooms exposed
to fire hazards, where flammable or explo-
sive vapours or dusts may be present (e.g.
in stables, barns or paint shops).
Only use this device to lift and lower the
vehicle, not to keep the vehicle in a lifted
position. Do not move it whilst raising or
lowering.
Do not use the equipment if oil leaks are
present.
After use return all parts used into their orig-
inal position. Have the hydraulic oil or oil
pump replaced by a professional if the parts
can no longer be moved.

Use

Q

Raising the vehicle

Q
CAUTION! RISK TO LIFE! Check that the
vehicle jack and axle stands are in an undam-
aged condition before you use them. Ensure that
the hydraulic vehicle jack is used only in combi-
nation with axle stands. Have your axle stands
to hand before raising the vehicle. If you do not
use axle stands, the vehicle may tip over and
cause a risk to life.
Follow these steps:
Ensure that the support plate
lowered and the extension screw
pletely screwed in before you put away the
vehicle jack.
Place the hydraulic vehicle jack in the desired
position. In choosing the position, observe
the provisions of the owner's manual for
your vehicle.
If necessary screw out the extending screw
until it comes into contact with the un-
2
derside of the vehicle (Fig. B).
3
Connect the rod
to extend the lifting handle.
CAUTION! RISK OF SHEAR-
ING AND CRUSHING IN-
JURY! Keep your fingers away
from the area of the lifting handle socket
while pumping. Failure to observe this advice
may result in shearing and crushing injury.
Guide the end of the lifting handle
the lifting handle socket
vehicle up to the desired height (Fig. D).
is fully
1
is com-
2
to the lifting handle
7
into
6
and pump the
3
GB/CY
6
3
7