Warning Messages - VOLTCRAFT B5 Bedienungsanleitung

16. Warning messages

REVERSED REVERSED
REVERSED REVERSED REVERSED
POLARITY POLARITY POLARITY
POLARITY POLARITY
CONNECTION CONNECTION CONNECTION
CONNECTION CONNECTION
BREAK BREAK
BREAK BREAK BREAK
SHORT ERR SHORT ERR SHORT ERR
SHORT ERR SHORT ERR
IN VOLTAGE IN VOLTAGE
IN VOLTAGE IN VOLTAGE IN VOLTAGE
ERR ERR ERR
ERR ERR
VOL SELECT VOL SELECT
VOL SELECT VOL SELECT VOL SELECT
ERR ERR ERR
ERR ERR
BREAKDOWN BREAKDOWN
BREAKDOWN
BREAKDOWN BREAKDOWN
BATTERY CHECK BATTERY CHECK BATTERY CHECK
BATTERY CHECK BATTERY CHECK
LOW VOLTAGE LOW VOLTAGE
LOW VOLTAGE LOW VOLTAGE LOW VOLTAGE
BATTERY CHECK BATTERY CHECK BATTERY CHECK
BATTERY CHECK BATTERY CHECK
OVER VOLTAGE OVER VOLTAGE
OVER VOLTAGE OVER VOLTAGE OVER VOLTAGE
BATTERY VOL BATTERY VOL
BATTERY VOL BATTERY VOL BATTERY VOL
ERR ERR ERR
ERR ERR
62
The polarity of the battery poles has been switched.
The connection to the battery has been broken,
e.g. if the battery has been disconnected during
the charging process.
A short-circuit has been established on the charger
output.
The input voltage (operating voltage) for the
charger is too low.
The voltage of a LiPo battery to be charged is
incorrectly configured.
The charger has established that there is an internal
problem. Should this message permanently be
displayed, it is possible that the charger is defective;
have it checked by a specialist workshop or
qualified technician.
During the charging process it has been established
that the battery has been totally discharged.
In this case you should check if the voltage of the
battery has been correctly set for the charging
process.
The voltage in one of the cells of a LiPo battery is
too high. This can occur if a multicell LiPo battery
has been charged previously without a balancer.