VOLTCRAFT B5 Bedienungsanleitung Seite 53


Be aware that when using the charging program "LiPo BALANCE CHG", both
the balancer battery connector and the battery connector cable must be
connected to the charger.
Use the correct balancer connector depending on the number of cells.
There are different types of balancer plug. For this reason, do not use force if
the plug does not fit! Suitable adapters are available to purchase for the
balancer plug.
Charge the LiPo battery as follows:
• After you have selected the "LiPo BALANCE CHG" charging program and confirmed with the
"Start/Enter" key, the following display appears (example):
LiPo BALANCE CHG LiPo BALANCE CHG LiPo BALANCE CHG
LiPo BALANCE CHG LiPo BALANCE CHG
2.0A 2.0A
2.0A 2.0A 2.0A
The value on the left in the second row shows the charge current, the value on the right shows
the voltage or number of cells in the LiPo battery (in this example, a 3-cell LiPo battery pack,
3x 3.7V = 11.1V).
• If the values need to be changed, press the "Start/Enter" key. The charge current begins to
flash. Change the charge current using the keys "INC" and "DEC", confirm the value using
the "Start/Enter" key.
The voltage then begins to flash. Change it using the keys "INC" and "DEC". You should be
aware while doing this that the voltage only changes with the number of cells (e.g. one cell
= 3.7V, two cells 7.4V etc.) Confirm the setting by pressing the "Start/Enter" button.
• To begin the charging process, keep the "Start/Enter" key pressed.
11.1V(3S) 11.1V(3S)
11.1V(3S) 11.1V(3S) 11.1V(3S)
53