Safety Warnings For The Electrical Equipment; Residual Risks - VM R750EU6 - TE4 Bedienungsanleitung

SAFETY WARNINGS FOR THE ELECTRICAL EQUIPMENT

The electrical equipment was designed
and manufactured according to the provi-
GB
sions of the standards in force on the mat-
ter. The list specifies some warnings to be
complied with for the correct operation of
the electrical equipment.
–Do not use boosters or quick starters to
start the engine.
–Do not disconnect the electrical power
supply when the engine is ON.
Before disconnecting the electrical
power supply, turn off the engine and
wait for at least 30 sec. so that the
electronic control unit can perform the
"after -run" procedure.

RESIDUAL RISKS

During the design and construction
phases, the Manufacturer paid special
attention to the aspects which are liable to
cause any risk for the safety and health of
people interacting with the engine.
Despite this, some potential and hidden
risks still exist.
English
R750EU6 - TE4 - IE4 - ISE4
–Before performing arc welding on the
frame where the engine is installed,
ALWAYS disassemble the electronic
control unit and protect all electrically
connected devices that are installed
close to the negative pole (mass).
Danger of injuring your arms
Do not put your hands inside any movin-
gpart.
Danger of being burnt
Pay attention to hot surfaces
32 2056G