Troubleshooting; Cleaning; Cleaning The Appliance; Cleaning The Turbine Unit - Parkside IAN 332669_1907 Bedienungsanleitung

Troubleshooting

The following table will help you to identify and rectify minor malfunctions:
Fault
No indication on the
display .
Water flow rate is insufficient
or the display value does not
change.

Cleaning

Cleaning the appliance

CAUTION
► To avoid irreparable damage to the appliance, ensure that no moisture can penetrate into
the battery compartment during cleaning.
► Do not use caustic, abrasive or solvent-based cleaning materials. These can damage the
surfaces of the appliance.
♦ Clean the surfaces of the appliance with a soft, dry cloth. For stubborn dirt, use a slightly
damp cloth with a little mild detergent.

Cleaning the turbine unit

♦ Unscrew the coupling
♦ Remove the sealing rings
sealing rings , the inside of the coupling
water. Replace the sealing rings
♦ Remove the turbine unit
PWM 4 A1
Possible cause
No battery inserted.
Battery is empty.
The appliance is in standby
mode.
Turbine unit is dirty.
including the tap connector
from the coupling
in the coupling
from the appliance and pull the turbine unit
Remedy
Insert a battery.
Replace the battery.
Press the
activate.
Clean the turbine unit
under running water.
from the appliance.
and the tap connector
and the tap connector
and in the tap connector
button to
. Clean the
under running
.
apart.
GB │ MT │
43 ■