Operation; Dismantling - Parkside IAN 332669_1907 Bedienungsanleitung

Operation

The appliance has three memory functions that meter the amount of water consumed.
The modes on the display
♦ Press the button
♦ Press the button
♦ Press the button
TOTAL 1
■ The water quantity is counted until it is reset (e.g. water consumption per day).
TOTAL 2
■ The water quantity is counted until it is reset (e.g. water consumption per season).
AUTO
■ The water quantity is counted per watering process up to an interruption of 3 seconds.
During the next watering process the display starts again at 0.
LITER/MIN or GAL/MIN
■ In this mode, the current flow rate is displayed in l/min or gal/min.
NOTE
► If no water flows through for longer than approx. 1 minute or if you do not press any key,
the appliance switches to standby mode.
► Press the button
Reset
♦ Press the button
the water quantity measurement to 0. You only reset the water quantity measurement for the
display mode you are currently in.

Dismantling

♦ Unscrew the appliance or tap connector
using a garden sprayer or similar, push the front part of the coupling
off the garden sprayer.
♦ Disconnect the water hose from the water hose connection
│ GB │ MT
■ 42
show the amount of water consumed either in litres or gallons.
to activate the display
repeatedly to switch to one of the other display modes.
to switch between litres and gallons.
again to activate the display
for 3 seconds in TOTAL 1/TOTAL 2 or AUTO display mode to reset
.
.
anticlockwise from the water connection. When
.
to the rear and pull
PWM 4 A1