Troubleshooting - Parkside PMSHM 2 A1 Bedienungs- Und Sicherheitshinweise

cover and press the reset
6
on the backside of the product using a sharp ob-
ject. If the displayed reading is still not right, press
the reset button
Note: Do not remove the batteries while using
RESET function.

Troubleshooting

Error
The measure-
ment is obvi-
ously too high
or low.
The display
is reading
"Lo" or "Hi".
The number
on the display
is not re-
8
acting.
You can
barely see the
number on the
display .
8
Electrostatic discharges can lead to malfunctions.
In the event of such malfunctions, remove the
batteries briefly and reinsert them.
again to calibrate again.
5
Possible causes and
solutions
Check whether the product is
set to the correct material.
Check if the measuring pins
are correctly pressed against
the material.
Repeat the measurement process.
The measurement range has
8
been exceeded or you have
not reached the measuring
range.
If the lock symbol
on the display
button
The batteries are low.
See the chapter "Inserting/
changing the batteres".
button situated
5
appears
12
, press the
8
.
4
2
GB 15