Legal Information - Ottobock 2R10 Gebrauchsanweisung

3) Slide the joint shell (see fig. 1, item 2) onto the foot adapter.
4) Insert the foot adapter into the prosthetic foot. In doing so, make sure
the rubber bumper meets the recess in the foot adapter.
5) Push the foot adapter into the prosthetic foot until the joint shell and foot
adapter sit fully in the recess in the prosthetic foot.
6) Slide the base plate (see fig. 1, item 3) onto the foot adapter from below.
7) Put the hexagon nuts (see fig. 1, item 5 ) onto the foot adapter from
below and tighten then (torque value: 6 Nm).
8) With the screw, attach the locking device for the hexagon nuts (see
fig. 1, item 4) to the base plate.
6 Cleaning
1) Clean the product with a damp, soft cloth.
2) Dry the product with a soft cloth.
3) Allow to air dry in order to remove residual moisture.
7 Maintenance
► A visual inspection and functional test of the prosthetic components
should be performed after the first 30 days of use.
► Inspect the entire prosthesis for wear during normal consultations.
► Conduct annual safety inspections.
8 Disposal
This product may not be disposed of with regular domestic waste in all juris­
dictions. Disposal that is not in accordance with the regulations of the coun­
try where the product is used may have a detrimental impact on health and
the environment. Please observe the information provided by the responsible
authorities in the country of use regarding return, collection and disposal
procedures.

9 Legal information

All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
9.1 Liability
The manufacturer will only assume liability if the product is used in accord­
ance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthor­
ised modification of the product.
12