Herunterladen Inhalt Inhalt Diese Seite drucken

Making A Bag Using The Bag Roll; Preserve Food With Vacuum - CASO DESIGN VC10 silber Original Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für VC10 silber:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Please make sure when vacuum rolls and bags of other producers are used, whether they
are also microwaveable and suitable for cooking under vacuum. Please note that a bar
vacuumsealer as this device can only be used with structured bags. You can buy a wide
range of different bags and rolls from CASO.
16.3

Making a bag using the bag roll

Place the unit on a dry place. Make sure the working area in front of the unit is free of
obstacles and wide enough to accommodate the food bags.
1. Unroll the bag to the desired length and cut the bag to the appropriate length with
precise and clear cut.
2. Open the lid and put one end of the bag on top of the black rubber strip, then
close the cover (see Step 1).
3. Lift the front of the device slightly. Press firmly on the right and left sides of the
lid until the lid hearable latches. Use both hands. (see Step 2).
4. Press the "Schweißen"-Button and the red LED control light starts flashing.
5. When the LED light turns off, the bag is sealed.
6. Now you have a custom-sized bag.
► Make sure that the bag you want to use is at least 8cm/3.1in. longer than the food.
Add another 2 cm/0.8in. each time the bag is re-used.
16.4

Preserve food with vacuum:

6. After that press the two cover-unlock buttons and the process is completed
(see Step3).
7. Check the appearance of the sealed bag; it should have a stripe across the
seal and no wrinkles otherwise the seal may not be complete.
8. If you need to interrupt the vacuum operation (e.g. the bag is incorrectly
positioned) first presses the "Stop" button and then the cover-unlock buttons.
Please note
1. Put the food that you want to preserve
inside the bag.
2. Clean and straighten the open end of
the bag, make sure that there are no
wrinkles or ripples on the panels of the
open ends.
3. Place the bag as shown on the picture
in the device. Do not place the bag
over the intake (A), otherwise the
vacuum ca not be generated correctly.
4. Lift the front of the device slightly.
Press firmly on the right and left sides
of the lid until the lid hearable latches.
Use both hands.
5. Press the "Vakuum"-button then the
bag will be automatically vacuumed
and sealed.
34

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis