Making A Bag Using The Bag Roll; Use Of The Function "Selectable Welding Time; Open A Sealed Bag - CASO DESIGN VC250 Original Bedienungsanleitung

Please note
► Suggest to vacuum seal one bag within 1 minute to let the appliance cool down enough.
► In order to vacuum seal liquid-based foods, such as soups, casseroles or stew, freeze
them first in a baking pan or tempered dish, vacuum seal them, label and stack them in
your freezer as soon as they are in frozen solid.
► Blanch the vegetables by cooking briefly in boiling water or microwave oven, cool them
down , then vacuum seal them in convenient portions.
► To vacuum seal the foods not frozen, two extra inches are required for bag length to
allow for expansion while freezing. Place the meat or fish on a paper towel and vacuum
seal with the paper towel in the bag, this way will help to absorb moisture from the
foods.
► Before storing the foods such as tortillas, crepes or hamburger, use wax or parchment
paper between them to stack the pieces, this will be easier to remove some of the food,
reseal the rest and immediately replace in the freezer.
► The vacuum preservation system can't be directly used for the vacuum sealing of
canisters or canning jars.

16.5 Making a bag using the bag roll

1. Unroll the bag to the desired length and cut the bag to the appropriate length with
precise and clear cut.
2. Open the lid and put one end of the bag on top of the black rubber strip, then close the
cover (see Step 1).
3. Press the cover down heavily on both sides by using two hands until two click sounds
heard (see Step 2).
4. Press the "Schweißen"-Button (B) and the corresponding LED control light starts
flashing.
5. When the LED light turns off, the bag is sealed.
6. Now you have a custom-sized bag.
Please note
► Make sure that the bag you want to use is at least 8cm/3.1in. longer than the food. Add
another 2 cm/0.8in. each time the bag is re-used.

Use of the function "selectable welding time"

16.6
When there are fluids in the bag and hence in the section where you want to seal it, the
welding procedure should be adjusted to "feucht". This would increase the welding time
and the bag is safely sealed. Press the button "trocken & feucht". If the lamp will illuminate
above "feucht", the welding time for moist vacuum food is adjusted.

16.7 Open a sealed bag

Cut the bag straight across with scissors or the cutter, just inside the seal.
40