Maintenance; Operating The Compressed Air Spray Gun; Prepare Spraying Surface; Switching The Compressed Air Spray Gun On/Off - Parkside PDLS 5 B1 Originalbetriebsanleitung

• Maintenance

WARNING!
DANGER OF INJURY!
Disconnect the device from the
compressed air supply prior to
maintenance work.
Clean the device after each use.
„
ATTENTION DAMAGE
TO PROPERTY
f Do not immerse the device fully into the
detergent, as this could cause damage
to the seals.
f Do not use any halogen solvents
which contain hydrocarbons such as
trichloromethyl, ethyl chloride etc.,
as they cause chemical reactions with
some substances from the compressed
air paint spray gun. This can lead to
hazardous reactions.
Flush the compressed air paint spray gun
„
through at low pressure with a container
filled with a suitable detergent.
Catch the liquid in a container and dis-
„
pose of the liquid in an environmentally
friendly manner.
Oil the moving parts of the trigger arm of
„
the compressed air paint spray gun
If you remove the nozzle when cleaning,
„
you must grease it afterwards.
When doing this, do not use lubricants
which contain silicone.

... / Operating the compressed air spray gun

• Operating the compressed
air spray gun

• Prepare spraying surface

Cover a large area around the spraying
„
surface carefully. Otherwise any
surfaces which are not covered could
be contaminated.
Make sure that the spraying surface is
„
clean, dry and free of grease.
Roughen up smooth surfaces and then
„
remove any sanding dust.
• Switching the compressed
air spray gun on/off
Tips for use:
When thinning, make sure that the
„
substance to be sprayed and the thinner
are compatible. If the wrong thinner is
used, lumps may form and as a result of
this, the compressed air spray gun can
get clogged.
Fill the suction pot
„
to be sprayed.
Screw the suction pot
„
clockwise direction firmly onto the
compressed air spray gun.
Always hold the compressed air spray
„
8 . gun at the same distance from the object.
The ideal spraying distance is approx.
15 cm.
Identify the appropriate settings in each
„
case by carrying out a test.
Do not switch the device on/off above
„
the spraying surface, start and finish the
spraying process approx. 10 cm away
from the spraying surface.
with the substance
4
4 in an anti-
GB 15