Set The Substance Quantity; Maintenance; Operating The Compressed Air Tyre Inflator - Parkside PDLS 5 B1 Originalbetriebsanleitung

... / Operating the compressed air tyre inflator

Switching on:
WARNING!
f The ventilation opening
suction pot bracket must always be
unobstructed. Stop work immediately
if compressed air or spray substance
comes out of the ventilation opening
3 . Correct the problem before
continuing to work.
f If you need to spray in a position
where the suction pot
angle, just fill it half full. In this way,
the spray substance will not come out
of the ventilation opening
Press to switch on the trigger arm of the
„
compressed air spray gun
pressed.
Switching off:
To stop operation, release the trigger
„
arm of the compressed air spray gun
again.

• Set the substance quantity

You can control the quantity of the substance
to be sprayed.
Undo the lock nut
„
Rotate the nozzle
„
position.
Fix the nozzle
1
„

• Maintenance

DANGER OF INJURY!
Disconnect the device from the
compressed air supply prior to
maintenance work.
Clean the device after each use.
16 GB
on the
3
4 is at a steep
3 .
6 and keep it
.
2
1 to the required
with the lock nut .
2
ATTENTION DAMAGE
TO PROPERTY
f Do not immerse the device fully into the
detergent, as this could cause damage
to the seals.
Flush the compressed air spray gun
„
through at low pressure with a container
filled with a suitable detergent.
Catch the liquid in a container and dis-
„
pose of the liquid in an environmentally
friendly manner.
Oil the moving parts of the trigger arm of
„
the compressed air spray gun
• Operating the compressed
air tyre inflator
Keep the valve lock
„
the clamp valve
6
the tyre to be inflated. Release the valve
lock 23 .
To inflate the tyre press the trigger arm
„
of the compressed air tyre inflator
Release the trigger arm of the com-
„
pressed air tyre inflator
check the tyre pressure on the pressure
gauge 18 .
Press the drain valve
„
pressure is too high. Doing this will
release air from the tyres.
PLEASE NOTE!
fThe pressure gauge
approved. Therefore you must check the
tyre pressure as soon as you can using a
suitable device at a petrol station or car
repair shop.
.
6
23 pressed and plug
onto the valve of
22
21
21 , in order to
19 , if the tyre
18 is not trade-
.