Technical Specifications; Residual Risk - Parkside PDLS 5 B1 Originalbetriebsanleitung

Introduction / Residual risk
Figure D:
18 Pressure gauge
19 Drain valve
Compressed air connection of the
20
compressed air tyre inflator
21 Trigger arm for the compressed air
tyre inflator
Clamp valve
22
23 Valve lock
Figure E:
24 Compressor connection
25 Quick coupling

• Technical specifications

Compressed air paint spray gun
PDLS 5 B1-1:
Working pressure:
Nozzle size:
Suction pot:
Recommended viscosity: 18–23 DIN / Sec.
Compressed air spray gun
PDLS 5 B1-2:
Working pressure: max. 8 bar
Nozzle size: Ø 3 mm
Suction pot: approx. 900 ml
Compressed air tyre inflator
PDLS 5 B1-3
Working pressure: max. 6 bar
Compressed air blow gun
PDLS 5 B1-4:
Working pressure: max. 5 bar
Compressed air hose:
Working pressure: max. 8 bar
Length: 5 m
8 GB
max. 5 bar
Ø 1.5 mm
approx. 1000 ml
Noise emission level:
Noise emission level measured according
to EN 14462. The estimated noise level in
the user's location:
Sound pressure level:
Compressed air
paint spray gun: LpA = 81.7 dB (A)
Compressed air
spray gun: LpA = 85.4 dB (A)
Compressed air
tyre inflator: LpA = 84.4 dB (A)
Compressed air
blow gun: LpA = 86.1 dB (A)
Uncertainty: KpA = 2.5 dB

• Residual risk

Even if you operate the devices as intended,
there will be residual risks. The following
dangers may occur in connection with the
build and design of this air compressor set:
Danger from whipping compressed
„
air hoses
Danger of falling from compressed
„
air hoses lying around
Reduce the risk by carefully using the devices
as intended and observing all instructions.
PLEASE NOTE!
f After unpacking the product, please
check that all of the package contents
are present and that the devices are in
perfect condition. Do not use devices if
they are defective.
Keep the packaging material out of reach of
young children. There is a risk of suffocation!