Mounting And Installation; Mounting In A 19" Rack; Equipotential Bonding - axing MIP 8-00 Betriebsanleitung

Operation instructions | MIP 8-00 | MIP 16-00 | MIP 8-06 | MIP 16-06

2. Mounting and Installation

 Installation must be performed by authorized and skilled electricians only.
 Before mounting and installation, pull the mains plug (1)!
 The antenna system must be installed and grounded according to the EN 60728-11 standard.
2.1.1.

Mounting in a 19" rack

Note: For 19-inch rack mounting, there must be at least 5 cm clearance in front of and behind the unit.
 Slide the device into the 19 "rack.
 Screw the device with four screws (1).
 Observe the standard EN 60728-11.
2.2.

Equipotential bonding

 The device must be connected to the equipotential bonding according to EN 60728-11. Use the
equipotential bonding connection at the device.
 To connect the outer conductor of the coaxial cable to the equipotential bonding, use e.g. QEW earthing
angles or CFA earth connection blocks at the inputs and output (see 2.4 on page 10).
8 2020-02-23 | Technical improvements, changes in design, printing- and other errors expected.