Cross Multiplex Mode - axing MIP 8-00 Betriebsanleitung

Assigning programmes
Every tuner is assigned to an MPTS. The programmes of the tuner can only be assigned to the associated
MPTS.
 For example, click in table TUNER 1 on M1.
The program is assigned to MPTS 1. The button of the MPTS is highlighted in color (a new click on a MPTS
allow the assignment to be canceled. The button fades then again).
Choosen
programs for
MPTS 1
 Choose the programs for TUNER 1 to TUNER 8/16.
 Click on SAVE CHANGES.
The assignment is saved to the device.
Note: If the option is activated, then no settings can be made in the columns LCN, decrypt etc.
3.4.4.

Cross Multiplex Mode

The cross multiplex mode is used:
•
To split the programmes of a transonder to several MPTS.
•
To merge pogams of several transponders into one MPTS.
Transmission capacities in the distribution networks can be optimized.
 Change the Network ID to a value greater than zero.
 Click on SAVE CHANGES.
The IDs of the transport streams TS ID1 to TS ID8[16] are automatically incremented by one to eight[16], the
cross multiplex mode is activated.
Important:
If you use several MIP in a network, then the network IDs must be the same and the network name should also
be the same. Transport stream IDs, on the other hand, may only be assigned once in the network.
2020-02-23 | Technical improvements, changes in design, printing- and other errors expected. 19