Initialization Phase 3; Spts - axing MIP 8-00 Betriebsanleitung

3.5.

Initialization phase 3

In PHASE 3, the output transport streams are configured.
3.5.1.

SPTS

If SPTS (Single Program Transport Stream) is selected as the transport stream output (see 3.6.2 on page 27),
then to each transport stream is assigned a destination address. You also define the port and the transmission
protocol.
Since there are up to 512 transport streams, there is the possibility of quick setup.
 Click on QUICK SETUP.
 Enter the start IP.
The other IP addresses are incremented by this Start IP (239.0.0.1, 239.0.0.2, 239.0.0.3 ...).
 Enter the port and as mode the transmission protocol.
 Click OK.
All transport streams are configured accordingly.
2020-02-23 | Technical improvements, changes in design, printing- and other errors expected. 23