Dvb-C, Dvb-T Or Dvb-T2 - axing MIP 8-00 Betriebsanleitung

3.3.2.

DVB-C, DVB-T or DVB-T2

Before connecting an antenna cable to a tuner, the LNB Power has to be set to Off!
 Click TUNER 1...8/16 to select one tuner.
 In the field LNB power choose the option Off.
 Enter the center frequency (see table below) for the receiving channel into the field Freq (MHz).
Channel Input
S 21 306
S 22 314
S 23 322
S 24 330
S 25 338
S 26 346
S 27 354
S 28 362
S 29 370
S 30 378
S 31 386
S 32 394
S 33 402
S 34 410
S 35 418
S 36 426
S 37 434
S 38 442
S 39 450
S 40 458
S 41 466
Note: The center frequeny of channels using a bandwith of 7MHz will be rounded down to 3 full digits. For
example: center frequency of CH 5 = 177,5 MHz, the according input = 177.
Note: All other entry fields are not relevant. Modulation and all other important parameter for reception are
detected automatically.
 If mutistreams are to be received, then the PLS mode must be set to root or gold. In addition, the correct
Stream ID (three digits) and the PLS code (six digits) must be entered.
 After all settings have been made, click SAVE & SCAN
2020-02-23 | Technical improvements, changes in design, printing- and other errors expected.
Channel Input Channel
21 474 41
22 482 42
23 490 43
24 498 44
25 506 45
26 514 46
27 522 47
28 530 48
29 538 49
30 546 50
31 554 51
32 562 52
33 570 53
34 578 54
35 586 55
36 594 56
37 602 57
38 610 58
39 618 59
40 626 60
.
Input Channel Input
634 61
642 62
650 63
658 64
666 65
674 66
682 67
690 68
698 69
706
714
722
730
738
746
754
762
770
778
786
794
802
810
818
826
834
842
850
858
15