Fill Level; Selected Programmes; Maintenance - axing MIP 8-00 Betriebsanleitung

3.5.3.

Fill level

The fill level depends on the number of activated channels in Phase 2.
The data rate of the channels on the DVB-S/S2/S2x transponders may vary depending on the image contents
and on the transmission quality. To ensure an undisturbed reception, a reserve must absolutely be observed.
We recommend you to set the maximum fill level to 95%. If the current fill level exceeds the maximal fill level,
it may cause image disturbances, such as mosaic images. The error LEDs on the front panel will light up in red
in this case.
3.5.4.

Selected Programmes

The programme table SELECTED PROGRAMS shows the programmes that were activated in phase 2.
3.6.

Maintenance

The menu entry MAINTENANCE enables software updates, changing the IP address, changing the password,
restarting the device and erasing service data.
Under Current Settings, you will find the following information:
•
Firmware version: Displays the firmware version
•
Software version: Displays the version of the interface
•
Serial number of the device
•
Processor temperature
•
Output voltage and temperature of the power supplies
2020-02-23 | Technical improvements, changes in design, printing- and other errors expected. 25