Output Transport Stream; Graphical User Interface - axing MIP 8-00 Betriebsanleitung

Direct connection to the LNBs
The devices have a remote supply voltage for the LNB and DiSEqC 1.0 functionalities at the inputs. The inputs
can be connected directly to the LNB.
Multiswitches as input distributors (recommended)
Optionally, you can also use multiswitches as input distributors. The advantage of this solution is that you can
set both the polarization and the satellite via the user interface. Changes in the list of programmes can be
made using remote maintenance, so that it is not necessary to change or modify the input distribution on site.
Demodulation of the data stream
The selection of the frequency and the demodulation of the data stream are both done in the tuner.
1.4.

Output transport stream

As Output transport stream 512 SPTS or 8 MPTS (MIP 8-0x) or 16 MPTS (MIP 16-0x) can be choosen.
SPTS: each program is attached to one transport stream. MPTS: multiple programs are attached to a transport
stream, using remux or crossmultiplex mode.
1.5.

Graphical user interface

The settings can be changed via the user interface of the integrated web interface. To access the user interface
and thus configure the devices, you need a standard PC/laptop with a network interface and the actual version
of the installed web browser.
The configuration interface is "mobile ready" and can therefore also be used from the smartphone or tablet.
2020-02-23 | Technical improvements, changes in design, printing- and other errors expected. 5