3.6.2.
Select transport stream output
Under TS OUTPUT, the type of transport stream and the number of transport stream packets are selected.
Depending on the configured transport stream, the output signals are output as MPTS (Multi Program
Transport Stream) or as SPTS (Single Program Transport Stream). You will configure in PHASE 2 and PHASE 3
according to your selection.
In the Select TS Outbox box, select MPTS or SPTS.
In the TS packets per IP packet field, select the number of TS packets.
Click SAVE & REBOOT.
The changes are made. The remaining time is displayed.
After rebooting log in again.
2020-02-23 | Technical improvements, changes in design, printing- and other errors expected.
27